![]() The next step is to decide how you are going to heat your liquid plastic. Lastly you will find that when heating the plastic it will give off some vapours, so only do this in a ventilated area and ideally wear a respirator to protect your lungs. ![]() ![]() It would also be a good idea to wear some goggles just in case some spilt plastic ends up a bit higher. Any spillages that may happen could result in some nasty burns so it is essential to be wearing heat resistant gloves, which will also protect you when handling hot tools. These additives must be mixed into the liquid plastic before heating.Īs you are going to be heating the plastic to a high temperature it is important to make sure you are wearing suitable clothes and some basic personal protection. You can also customise the hardness of Liquid Plastic if you wish by adding softener or hardener at around 10 to 20%. For worm or slug type lures for example you will probably want to use a soft plastic and for shads you may want something a bit firmer. When buying liquid plastic you can choose what hardness you require for your lure depending on the application. This thin milky liquid requires heating to around 170☌ for it to change into a clear and slightly thicker liquid, that when poured into your mould and allowed to cool will form your finished soft plastic lure. The base material you will be using for this is Liquid Plastic. 3.5K After showing us how to make the mould, Alan Banks explains how to pour your first custom plastic lure.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |